Cobalt-digital COMPASS 9011 Standard Definition D_A 10-bit SDI to Manuel d'utilisateur télécharger pdf (Page 13)

9011 Owner’s Manual •

••

• (V 1.1) Page 13 of 22

Board Installation

Use the following steps to install the card in the frame:

1. Refer to the frame product manual to ensure that the frame is properly installed

according to instructions.

Warning

Heat and power distribution requirements within a frame may dictate

specific slot placement of cards. Cards with many heat-producing

components should be arranged to avoid areas of excess heat build-up,

particularly in frames using convection cooling.

2. After selecting the desired frame installation slot, hold the card by the edges and

carefully align the card edges with the slots in the frame. Then, fully insert the card

into the frame until the rear connection plugs are properly seated on the midplane and

rear modules.

3. Connect the input and output cables according to the diagram for the rear module

being used. The inputs are internally terminated with 75 Ohms. It is not necessary to

terminate unused outputs.

This completes the procedure for installing the card in the frame.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Pas de commentaire

Cobalt-digital COMPASS 9011 Standard Definition D_A 10-bit SDI to Manuel d'utilisateur Page 13