Cobalt-digital FUSION 3G 9901-UDX 3G_HD_SD Up Down_Cross Converte Manuel d'utilisateur Page 53

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 128
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 52
9901-UDX-OM (V1.15) 9901-UDX PRODUCT MANUAL 2-15
Installation and Setup Connecting To Phoenix Terminal Connectors
Connecting To Phoenix Terminal Connectors
Figure 2-4 shows connections to the card Phoenix terminal block
connectors. These connectors are used for card analog audio, serial comm,
and GPIO connections. These terminal blocks use a removable screw terminal
binding post block which allows easier access to the screw terminals.
Note: It is preferable to wire connections to Phoenix plugs oriented as shown in
Figure 2-4
rather than assessing polarity on rear module connectors. Note
that the orientation of rear module connectors is not necessarily consistent
within a rear module, or between different rear modules. If wiring is first con-
nected to Phoenix plug oriented as shown here, the electrical orientation will
be correct regardless of rear module connector orientation.
Setting Up 9901-UDX Network Remote Control
Perform remote control setup in accordance with Cobalt
®
reference guide
Remote Control User Guide (PN 9000RCS-RM).
Note: If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt
®
reference guide Remote
Control User Guide (PN 9000RCS-RM) provides thorough information and
step-by-step instructions for setting up network remote control of
COMPASS cards using DashBoard. (Cobalt
®
OGCP-9000 and
OGCP-9000/CC Remote Control Panel product manuals have complete
instructions for setting up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the
Support>Documents>Reference Guides link at www.cobaltdigital.com
and then select DashBoard Remote Control Setup Guide as a download, or
contact Cobalt
®
as listed in Contact Cobalt Digital Inc. (p. 1-34).
If installing a card in a frame already equipped for, and connected to
DashBoard, no network setup is required for the card. The card will be dis-
covered by DashBoard and be ready for use.
Vue de la page 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 127 128

Commentaires sur ces manuels

Pas de commentaire