Cobalt-digital COMPASS 9253 2x4 AES Audio Distribution Amplifier, Manuel d'utilisateur télécharger pdf (Page 9)

Rear Module Installation

If you are installing the card into a slot with no rear module, you should have ordered and received an

appropriate 9253 rear module. You will need to install it in your frame before you can connect cables.

Use the following steps to install a rear module in the frame:

1. On the rear of the frame, locate the card frame slot.

2. As shown in Figure 2, seat the bottom of the rear module in the seating slot at the

base of the frame’s back plane.

Figure 2. Rear Module Installation

3. Align the top hole of the RM-9253-A with the screw hole on the top edge of the

frame back plane.

4. Using a Phillips driver and the supplied screw, fasten the rear module to the frame

back plane. Do not over tighten.

All modules are installed using the same method above.

The following section contains a drawing of the RM-9253-A module.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Pas de commentaire

Cobalt-digital COMPASS 9253 2x4 AES Audio Distribution Amplifier, Manuel d'utilisateur Page 9