Cobalt-digital COMPASS 9223 Dual-Channel 3G_HD_SD MPEG-4 Encoder Manuel d'utilisateur télécharger pdf (Page 76)

76 9223-OM (V2.0)

If you would prefer to make the output selection by Destination Address and UDP Port, set

Stream Display to Stream Addresses; this option is illustrated below.

To make the connections, simply check the Connect box in front of the input you wish to use.

You can connect any source to as many outputs as you wish. Conversely, unchecking the box

disconnects that particular source-destination pair.

Source Selection in the Output Ports

When configuring an output (ASI or IP), connections can be immediately made as well, in that

output’s configuration interface (see ASI Ports: Configuration Tab and IP Outputs:

Configuration Tab). The selection parameters are depicted below. The user-defined names for

the Encoders (and Test Packet Generators) are displayed in the user interface to facilitate

identification. To make the connection, just click on the corresponding checkbox under

Connect. Note that if an encoder channel is not available (either because it is not installed, or

because it has been configured for HTTP Live Streaming), it will not show in the list.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 99 100

Pas de commentaire

Cobalt-digital COMPASS 9223 Dual-Channel 3G_HD_SD MPEG-4 Encoder Manuel d'utilisateur Page 76