Cobalt-digital COMPASS 9223 Dual-Channel 3G_HD_SD MPEG-4 Encoder Manuel d'utilisateur télécharger pdf (Page 11)

11 9223-OM (V2.0)

Status Power OK

VID 2

ASI 2

ENC 2

VID 1

ASI 1

ENC 1

ETH 2 ETH 1

Top Corner

The 9223 board has other LEDs that may or may not be illuminated. They are intended for

engineering debug only.

Front Switches

The 9223 has two pushbutton-type switches in the front, just below the LEDs, as depicted below.

Their operation is as follows:

• Default IP Switch: This switch is used to recover the board in the unlikely case of a

corrupted or broken firmware update. In most cases, the 9223 will detect the error and

automatically fall back into the factory-default firmware load. If it does not, pull the card

out, press and hold this switch, and push the card back into the frame while still holding

the switch. You can release the switch once the Status LED turns orange. This action

causes the card to revert to the factory-default firmware.

• Reset Switch: Pressing this pushbutton switch causes the card to reset.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 99 100

Pas de commentaire

Cobalt-digital COMPASS 9223 Dual-Channel 3G_HD_SD MPEG-4 Encoder Manuel d'utilisateur Page 11