Cobalt-digital COMPASS 9223 Dual-Channel 3G_HD_SD MPEG-4 Encoder Manuel d'utilisateur télécharger pdf (Page 41)

41 9223-OM (V2.0)

Advanced Tab – Mux Parameters

These parameters control the details of the audio/video multiplexing, and the (P)SI tables. If the

Output Protocol in the Encoder Connections Tab is set to RTMP, these parameters will not be

shown as RTMP does not use the Transport Stream container.

The following Mux Parameters are always available if the Output Protocol is not set to RTMP:

• PMT PID, PCR PID, Video PID, Audio PID: These parameters control the Packet

Identifier (PID) values for the PMT, PCR, Video and Audio. The values can be entered

in hexadecimal (prefixed by 0x) or in decimal. Valid values are from 0x20 (32) to

0x1FFE (8190). PMT PID, Video PID and Audio PID must be distinct values. PCR PID

can either be the same as the video PID or distinct from the other values as well. The

user interface will not accept an invalid entry at any time – it will immediately revert to

the previous value. If additional audio channels are enabled, there will be additional

entries for their corresponding PIDs.

• Program Number: Enter the desired program number for this encoder channel. Valid

program numbers go from 1 to 65535 and are always entered in decimal.

• Transport Stream ID: Enter the desired Transport Stream ID for this encoder channel.

Values in this field can be entered both in hexadecimal (prefixed by 0x) or in decimal.

• Generate SDT: This box is always shown but is not selectable for the HTTP Live

Streaming and RTMP protocols. If this box is checked, an SDT will be generated for this

encoder channel. Additional SDT parameters become available once this box is checked,

as depicted below.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 99 100

Pas de commentaire

Cobalt-digital COMPASS 9223 Dual-Channel 3G_HD_SD MPEG-4 Encoder Manuel d'utilisateur Page 41